OMNI TUF200F Type L1 Wall Mount Ultrasonic Flow Meter

FLOW METER This low cost clamp on ultrasonic flowmeter is ideal for long-term deployment for flow measurement and closed-pipe applications, such as liquid process control, water flow measurement (hot/chill water, city water, sea water), sewage and sludge measurement, and measurements of oil (crude/diesel/fuel), chemicals (alcohol, acids, etc.), beverage, and many other liquids. Once the sensors are clamped on the pipe using the supplied stainless steel straps it can be programmed in a matter of minutes via the front keypad. In addion to the 4-20mA and pulse outputs the unit can also communicate via GSM modem. OMNI-TUF-200F Wall Mount Ultrasonic Flowmeter supplied with transducers for pipe sizes 15-100mm or 100 - 700mm, complete with manual and stainless steel straps.  Features: High accuracy. Normally, ±1%. When on-site calibration available, ±0.5%. Wide flow range 0.03 to 105ft/s. Wide pipe size range (from 1" to 240"). Noninvasive. No pipe disturbance. No moving parts, no pressure drop. Easy and economical installation. No cutting pipe, non drilling hole. Suitable for all commonly used pipe materials Easy to use and set up. Self-explanatory menu programming Velocity, volumetric and totalized flow GPRS / GSM networking capability with certain model Ideal for both clean and opaque liquid flow measurements Specification Linearity    0.5% Repeatability    0.2% Accuracy    Normally better than ±1%. Could be ±0.5% with on-site calibration. Response Time    0.5 Seconds Display    Backlit LCD 2x20 Characters. Display instantaneous flow rate, accumulated flow rate (positive, negative and net rates), velocity, time, analog inputs, etc. Units    English (U.S.) or metric Signal Outputs    Current output: 4-20mA or 0-20mA. Impedance 0-1k OCT output: pulse signal for accumulated flow rate (positive, negative and net rates); frequency signal for instantaneous flow rate (0-9,999Hz selectable) Relay: output 20 signals, such as no signal, reverse flow & more Signal Inputs    5 channel analog signal inputs (for signals such as temperature, pressure, liquid level, etc.) Data Logger    Automatically record the following information: 1) The totalizer data of the last 64 days / 64 months / 64 years 2) The power time and corresponding flow rate of the last 64 times power on and off events 3) Allow manual or automatic flow loss compensation 4) The instrument working status of the last 64 days. Computer Interface    RS232 Enclosure    Protection Class: IP65 (NEMA 4X) Liquids    Type: Virtually all commonly used liquids (full pipe) Temperature: 32ËšF - 212ËšF (0ËšC - 100ËšC) Concentration: <10,000ppm and small air bubble concentration Pipe    Sizes: 1" - 240" Materials: All metals, most plastics, fiber glass, etc. Pipe Length: Better longer than 15D, where D is pipe diameter. If a pump is near, the straight pipe section following the pumps should be > 30D Cable    Shielded transducer cable. Standard length 15ft (5m). Can be extended to 1640ft (500m). Contact the manufacturer for longer cable requirement. Cable should not be laid in parallel with high-voltage power lines, neither should it be close to strong interference source such as power transformers. Power    8 to 36VDC, 80 to 265VAC optional with PSU   Transducer Specifications Type S1    Small size transducer (magnetic) For pipe size ½” – 4” Type M1    Standard medium size transducer (magnetic) For pipe size 2” – 28” Type L1    Large size transducer (magnetic) For pipe size 11” – 240”